FREE UK delivery

over £20 + Same day dispatch

EARN EVO COINS

WITH EVERY PURCHASE

Our customers say

Vape tank with droplets spitting from the drip tip and an 8 tips badge, for a guide on how to stop vape tank spitting and gurgling, with the Evolution Vaping logo

How to Stop Your Vape Tank Spitting and Gurgling: 8 Tips

Written by: Christian Jones

|

|

Time to read 5 min

How to Stop Your Vape Tank Spitting and Gurgling

There's nothing quite like it. You settle in for a lovely, smooth vape, take a draw, and get a gurgle like a blocked drain followed by a hot little spit of e-liquid on your tongue. Lovely. Not.

The good news? Vape tank spitting and gurgling are almost always easy to fix. More often than not it comes down to something simple, like the wrong e-liquid, the wrong wattage or a bit of condensation. Work through these tried-and-tested tips and you'll be back to smooth, spit-free vaping in no time.


Why Do Vape Tanks Spit and Gurgle?

In short, there's more liquid around your coil than it can turn into vapour. That excess liquid pools in the coil or airflow, then gets pulled up when you draw, giving you that tell-tale gurgle and spit. Our tips below tackle every common cause.


Eight Tips to Stop Your Vape Tank Spitting

TIP 1Check for a flooded coil

Flooding happens when the coil soaks up more e-liquid than it can vaporise. It's the most common reason for a vape tank spitting, and it's usually because the coil isn't hot enough.

Your draw matters too. Lots of short, gentle puffs can pull liquid in without heating it properly.

The fix: Take the tank off, wrap the mouthpiece end in tissue and gently blow through it to clear the excess. Then nudge the wattage up a little and take longer, smoother draws.

TIP 2Use the right e-liquid

E-liquid that's too thin for your coil is a classic cause of flooding. A 50/50 liquid can rush straight through the big wicking holes of a sub-ohm coil, while a thick 70/30 might struggle to soak into a small, tight coil.

The fix: Use higher-VG liquids, such as 70/30, in sub-ohm tanks, and 50/50 or nic salts in MTL tanks and pod kits.

TIP 3Check your wattage settings

Every coil works best within a certain wattage range. Too little power and it won't vaporise the liquid quickly enough, causing gurgling. Too much and you'll burn the cotton and wear the coil out early.

The fix: Check the range printed on your coil. Start at the lowest recommended setting and work up a watt at a time until you find your sweet spot.

TIP 4Watch your filling technique

It's easy to cause a flood before you've even taken a puff. Overfilling, or letting e-liquid drip down the centre tube, sends liquid straight into the coil and airflow.

The fix: Fill slowly down the side of the tank, avoid the centre tube and leave a small gap at the top.

TIP 5Check for a faulty coil

Coils are made in huge numbers, and it's impossible to test every single one, so you'll occasionally get a dud. If the wire isn't connected properly or the cotton isn't sitting right, liquid ends up where it shouldn't and gurgles or spits. Rarely, a coil won't work at all.

The fix: If a brand new, properly primed coil misbehaves from the start, swap it for another one.

TIP 6Try a new coil

Coils don't last forever. As you vape, the cotton slowly breaks down and residue builds up on the coil, which is why old coils look discoloured. A tired coil can't wick or vaporise properly, so it starts to bubble and spit.

The fix: Change your coil as soon as you notice a drop in performance or a slightly burnt taste. Most last one to three weeks.

TIP 7Wipe away condensation

Heat plus liquid equals condensation. It's no surprise that moisture builds up in the mouthpiece and airflow, especially in such a small space.

The fix: Make it part of your routine. Wipe the drip tip and airflow regularly, and give the whole tank a proper clean every so often.

TIP 8Check your tank for damage

A tank or pod that's put together properly forms a seal that keeps your e-liquid where it belongs. A damaged o-ring or a tank that isn't screwed together fully breaks that seal and lets liquid escape.

The fix: Check the o-rings and rubber seals for splits, and make sure every part is screwed together firmly but not overtightened.

New coil? Prime it first

When you fit a fresh coil, let the tank soak for five to ten minutes before you vape, then start at the lowest recommended wattage. It is the best way to avoid both gurgling and dry hits.


Quick Fix Table

In a hurry? Match what you're hearing (or tasting) to the most likely fix:

What's happening Likely cause Quick fix
Gurgling Liquid in the airflow Blow it out through tissue, then raise the wattage slightly
Spitting hot liquid Flooded coil or wattage too low Clear the flood and nudge the power up
Leaking from the base Thin liquid, overfilling or damaged seals Use the right ratio, fill carefully and check the o-rings
Wet mouthpiece Condensation Wipe the drip tip and airflow
Gurgling and burnt taste Worn-out coil Replace the coil

Spitting and Gurgling FAQs

Why is my vape tank spitting?

Spitting usually means liquid is pooling on or around the coil faster than it can be vaporised. Common causes are a flooded coil, the wattage being too low, an e-liquid that is too thin for your coil, or a worn-out coil.

How do I stop my vape tank gurgling?

Remove the tank, wrap the mouthpiece end in tissue and gently blow through it to clear excess liquid. Then raise the wattage a little, take smoother draws and wipe away any condensation.

What wattage should I use?

Check the recommended range printed on your coil. Start at the lower end and increase it a watt or two at a time until the vape is smooth and full of flavour.

Why does my new coil gurgle?

A new coil can flood if it is over-primed or fired too gently. Let it soak for five to ten minutes, start within the recommended wattage range and take a few short puffs to get it going.


Conclusion

Most cases of vape tank spitting and gurgling come down to a handful of simple causes, and a quick check usually sorts them out. Use the right e-liquid, match your wattage to your coil, fill carefully and keep things clean, and you'll enjoy a smooth, spit-free vape.

If you've tried everything here and your tank is still playing up, it's worth contacting the manufacturer, as there may be an issue specific to your model.

Related Blogs / Guides

Sunday,Monday,Tuesday,Wednesday,Thursday,Friday,Saturday
January,February,March,April,May,June,July,August,September,October,November,December
Not enough items available. Only [max] left.
Shopping cart

Your cart is empty.

Return To Shop

Estimate Shipping
Add A Coupon

Estimate Shipping

Add A Coupon

Coupon code will work on checkout page

Menu
Categories